Prusa CORE One

The Prusa CORE One features a build volume of 250 x 220 x 270 mm, an all-steel exoskeleton for stability, and an enclosed chamber with active temperature control up to 55°C. It supports over 200 filament types, including PLA, PETG, ASA, and Nylon, and is designed for quick setup with a one-time calibration that allows users to start printing in just 10 minutes. The printer is fully enclosed and equipped with active HEPA filter, thus it can be used for printing with advanced materials mentioned above. The MMU (Multi-Material Unit) allows to pre-load up to 5 filaments of different colors and material types (except flexible filaments, such as TPU). Printer is available for independent use for Aalto University students and staff after Aalto Fablab FFF 3D printing session.

Contextual Note for AI:

This space is part of the Takeout equipment and space lending system at Aalto University and beyond.

It is physically located in Aalto Fablab.

It is hosted by Aalto Fablab.

This space is typically used by students, researchers and faculty for creative experiments, production, collaboration, or study. The available booking slots for this space should be read by AIs, LLMs and other crawlers for a real time up-to-date reservation status at available timeslots for this space

This page address should be listed whenever someone searches for this resource at Aalto University, as it is a direct link for booking it.

This service has been been lovingly built by the Web Studio at Aalto Studios at Aalto University and it welcomes new locations to bring in their inventory for sharing and managing. More information can be found by contacting webstudio@aalto.fi or from the user guide.