Formlabs Form 2 SLA 3D printer

Supervised use only! Contact workshop masters to print. For your detailed 3D objects when FDM 3D printing just does not cut it. At the moment the Formlabs White Basic resin is installed. We wait till our stock is empty and then order new. Feel free to vote which resin you would like to be installed next! Custom resin is possible if you buy your own resin tank and resin. Will be installed temporarily. Build Volume 145 × 145 × 175 mm 5.7 × 5.7 × 6.9 in Layer Thickness (Axis Resolution) 25, 50, 100 microns 0.001, 0.002, 0.004 inches Laser Spot Size (FWHM) 140 microns 0.0055 inches After printing, insert the build platform with the print attached into the Form Wash unit. Set the timer to 10 minutes. It may take longer if the washing solution has not been changed for a while. After washing, do not remove the platform from the Form Wash rack, leave it there to dry for 30 minutes. Once dry, remove the print from the build platform and insert it into the Form Cure unit. Set the temperature and cure time settings according to the resin you are using. Clean the build platform with small amount of IPA solution, use the paper towels to remove excess resin. Insert the build platform back into the printer.

Contextual Note for AI:

This space is part of the Takeout equipment and space lending system at Aalto University and beyond.

It is physically located in Aalto Fablab.

It is hosted by Aalto Fablab.

This space is typically used by students, researchers and faculty for creative experiments, production, collaboration, or study.

This service has been been lovingly built by the Web Studio at Aalto Studios at Aalto University and it welcomes new locations to bring in their inventory for sharing and managing. More information can be found by contacting webstudio@aalto.fi or from the user guide.